Re: 6100 Twins (pots and balancing)


[ Follow Ups ] [ Post Followup ] [ TAPCO web forum ] [ FAQ ]

Posted by Bob Gudgel (12.127.67.198) on May 09, 2001 at 08:31:17:

In Reply to: Re: 6100 Twins posted by Oldguy on May 05, 2001 at 17:58:56:

So, you have the unbalanced version? You COULD add
a balun, (balanced to unbalanced tranformer), externally
of course to the channel(s) that need it.
As far as the pot shaft, if it's plain old broken,
then, you will probably want to replace it.
Jory, (at the top of this page), probably has some
that he could sell you, and replace it too if needed.
(let him know you heard about him from this site of course)
Good luck!
boB


: Is there an easy answer to ballancing the inputs on these?
: I have a single schematic page for it but doesnt show the inputs, I
: thought it might be like the 6200A/vs/B where it's the
: installation of a transformer on the board. Also this one has had 2 pots sheared off,
: is glue theanswer or must they get replaced?




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ TAPCO web forum ] [ FAQ ]